S&S Cycle Power Tune Sport Exhaust System for 2014 Harley-Davidson Sportster Models (PN 550-0379 and 550-0380) - Manual (Page 3)

10. Install the header by carefully inserting the rear head pipe and
flange first then rotate the header forward and up to insert the
front head pipe and flange.
11. Install the flange nuts to hold the header in place, but do not fully
tighten yet.
12. Pull the header outward slightly and install the two carriage bolts
to the to the slotted channels in the back of the header. Place two
washers on each carriage bolt between the header and bracket.
(See Picture 5).
13. Push the header back toward the mounting bracket. Make sure the
carriage bolts go through the holes in the mounting bracket.
14. Put a drop of Loctite on the exposed threads and loosely install the
jam nuts.
15. Tighten the exhaust port flange nuts followed by the mounting
bracket flange nuts.
16. Sufficiently tighten the two nuts that hold hold the exhaust header
to the bracket.
17. Adjust alignment of the front and rear heat shields and tighten the
clamps.
18. Apply a small amount of anti-seize compound to the threads of the
oxygen sensors and adaptors then re-install. Be careful not to get
any anti-seize compound on the tip of the sensor, as this may affect
its functionality.
19. Reconnect the front and rear oxygen sensors.
20. Install the pin and clip that connect the bract actuator rod to the
master cylinder.
21. Inspect the exhaust system and make sure there is sufficient space
between the exhaust system and motorcycle accessories.
22. Thoroughly clean the exhaust system to remove any fingerprints or
oil before the motorcycle is started
3
Picture 5
Picture 4