S&S Cycle Power Tune Duals For Touring Models 1995-2008 (PN 550-0003 & 550-0142) - Manual (Page 3)

3
18- Install heat shields. Connect and loosely tighten all worm gear clamps. Position screw heads for easiest access and tighten with a ¼" nut driver
or screwdriver.
19- Install mufflers. Torque left and right muffler and header/crossover supplied Torca/AccuSeal clamp. Make sure header/crossover clamp does
not contact frame. Tip: Use anti-seize on threads of used muffler clamps. If they clamp down securely they don’t need to be replaced, however
they may be stretched and require replacement.
20- Place the provided floorboard spacers between the frame and floorboard brackets and install in the lowest position. Apply Loctite® and use the
3/8" Allen wrench to tighten the bolts. Next, install the floorboard to the brackets with the original fasteners.
21- Reconnect oxygen sensor electrical plugs.
22- Before operating motorcycle, clean pipes and mufflers with soap and water or window cleaner. Any grease or oil will permanently burn onto
pipes. Dry thoroughly.
Carefully read the enclosed Important Notice sheet. Re-jetting and or recalibration may be required.
Check all mounting hardware to be sure it is tight before and after first operation of motorcycle. Periodically, check tightness of all
mounting hardware.
USE AND CARE: Wash your accessories with the same care you use when washing your motorcycle. Use mild soap and water. DO NOT use abrasive
chemicals or cleaners, or high pressure washers.
Cover ends of mufflers when washing motorcycle. Mufflers may internally corrode if saturated with water and allowed to sit.
CONTENTS
Description
Qty
Header weldment 1
Crossover weldment 1
Torca/AccuSeal Clamp 1
Front heat shield 1
Rear heat shield 1
Left heat shield 1
Heat shield clamps 10
Crossover Spacer Weldment 2
¼-20 x 3.50 oil pan bolts
4
Oil pan washers 4
O2 plugs 2
O2 washers 2
Floorboard spacers 2
Exhaust port gaskets 2
CAUTION
WARNING
CAUTION