S&S Cycle Engine Shipping Crate 50-9578 - Manual

S&S
®
Cycle, Inc
.
14025 Cty Hwy G PO Box 215
Viola, Wisconsin 54664
Phone: 608-627-1497 • Fax: 608-627-1488
Technical Service Phone: 608-627-TECH (8324)
Technical Service Email: [email protected]
Website: www.sscycle.com
Instruction 510-0082
07-12-12
Copyright © 2012
by S&S® Cycle, Inc.
All rights reserved.
Printed in the U.S.A.
Packing Instructions:
for #50-9578 S&S Engine Shipping Crate
Introduction
S&S engine shipping crates are designed to provide a safe and secure method for packing and shipping engines to S&S for warranty or
remanufacturing service.
NOTE: S&S Cycle assumes no liability for damages incurred during shipping to or from S&S, and strongly recommends that contents be insured for an
appropriate amount. Should damage occur, the carrier must be notified immediately.
Packing an engine in the crate is simple and straightforward as explained in the following instructions. The crate comes complete with everything
you will need for assembly except packing tape. The engine will be held in place and protected by preformed foam packing blocks that are form
fitted to a v-twin big twin engine.
Due to heavy weight of an engine, care must be taken to avoid back strain or other injury while placing the engine in the crate or when
moving the crate. S&S recommends that a hoist be used if possible.
1. Protect the rocker boxes of the engine with sheets of plastic wrap. See Picture 1, below
WARNING
Picture 1