S&S Cycle Packing Harley-Davidson Twin Cam 88B Engine in S&S Shipping Crate 50-9589 - Manual (Page 2)

2
Remove the crate liner and base from the crate. Set the
motor on the base and install the long bolt through the
front motor mount hole.
Line up the rear of the motor and install the supplied
bolts to the rear of the motor, making sure that you use
three washers on each of the rear bolts.
After the motor is secured to the base, place the motor
and base into the crate. Install the box liner with the
notches facing the top of the crate. The 2" x 4" x 20
3 ⁄
8
"
board should go across the top of the box above the
motor and be secured with nails, screws, or staples to the
sides of the crate.
Any extra parts to be shipped along with the engine
should be boxed and placed in the crate beside the
motor. Anything placed in the crate must be secured so
no damage occurs during shipping.
When closing up the crate secure the lid to the 2" x 4"
that runs across the top with nails, screws, or staples. Use
tape to secure the top flaps.
Using good judgment will avoid damage to your
motor and parts during shipping. If you have any
questions about proper packaging call the tech line at
608-627-TECH (8324).
Picture 2
Picture 3 Picture 1
Because every industry has a leader