S&S Cycle Rocker Cover Wrench Set - Manual (Page 2)

2
S&S ® rocker cover wrenches are designed to simplify installation and removal of S&S rocker covers.
Tool 53-0041 ( 3 ⁄
16
" x .35") is intended for sockethead capscrews used on the outside cover. Tool 53-0042 ( 3 ⁄
16
" x 1.05") is for screws used
inside covers. Tool 53-0043 ( 1 ⁄
4
" x .25") is for rocker shaft support screws. Tool 53-0044 ( 1 ⁄
4
" x 1.05") is for screws used inside covers of
1999-up engines.
NOTES:
●
S&S recommends use of torque wrench with rocker cover wrenches whenever possible. However, S&S rocker cover wrenches can
also be used with 5⁄8" box or open-end wrench where space limitations prevent use of torque wrench. Use properly torqued bolt
as reference for tightening bolt inaccessible with torque wrench.
● It remains engine builder’s responsibility to apply correct grade of Loctite ® to screw threads during assembly, and to tighten
hardware according to product manufacturer’s specifications. 1 ⁄
4
" o.d. rocker cover screws provided in S&S rocker cover kit should
be tightened to 10-13 ft-lbs. 5 ⁄
16
" o.d. rocker support screws should be tightened to 15-18 ft-lbs. S&S has used Loctite ® 242 on rocker
cover and rocker support screws with good results. It is important to clean threads with Loctite ® primer or lacquer thinner prior to
applying Loctite ® .
● Chrome build-up in plated bolts may prevent insertion of S&S wrench. Wire brush or fine file can be used to remove rust-
preventive finish from wrench and improve fit. If finish is removed, wrench should be coated with thin film of oil before storage
to prevent rust.
● Removing excessive material from wrench will cause poor fit, allowing wrench to slip inside screw socket and cause possible
damage to plating or screw.
● Failure to apply Loctite to threads or tighten screw to correct torque specifications may result in screw vibrating loose and causing
extensive engine damage not covered under warranty.
● Lacquer thinner and many other solvents are potentially hazardous. Read manufacturer’s instructions prior to use and
heed all cautions.
CAUTION
WARNING
S&S ® recommends use of torque wrench with rocker cover
wrenches whenever possible.
A 5/8” box or open-end wrench can be used where space
limitations prevent use of torque wrench.
Because every industry has a leader