S&S Cycle X-Wedge Rubbermount (XW-R) Transmission Case with Engine and Swing Arm Mount - Manual (Page 2)

2
*Note that the pictures used for the instructions were taken using an engine stand, not an actual frame.
1- Insert the swing arm pivot axle through the frame and the rear of the transmission case.
2- Use a jack to support the front of the transmission. Position the jack to allow clearance for the inner primary to slip on and allow access to the
two mounting holes.
3- Adjust the height of the jack and get the transmission as level as possible. (If a jack is not available then blocks of wood and shims may be used
to achieve this.)
4- At this point the motor may be installed into the frame.
5- Once the engine is in the frame and resting on the front engine mount and the rear engine mount is resting on the transmission case, you can
line up the mounting holes and insert the front mounting bolts. Leave them loose at this point. See Picture 3.
Picture 1
Picture 2
Picture 3
Insert two front
motor mount bolts