RKI Instruments 65-2331RK - Manual (Page 12)

8 • 65-2331RK H
2
S Transmitter
11. Connect the wires to the applicable detector/transmitter terminal strip at the
controller as shown in Figure 4.
Figure 4: Wiring the H
2
S Transmitter to a Controller
12. If shielded cable is used, connect the cable’s drain wire to an available chassis (earth)
ground at the controller. RKI controllers typically have a ground stud that can be used
to ground the cable’s drain wire.
Start Up
This section describes procedures to start up the H
2
S transmitter and place the transmitter
into normal operation.
Introducing Incoming Power
1. Complete the installation procedures described earlier in this manual.
2. Verify that the power wiring to the controller is correct and secure. Refer to the
controller operator’s manual.
S
ZE
R
O
SP
A N
SI G
/P
W
R
Red
T O
X IC
O
X Y
Black
H2S Detector
+
Controller Detector/Transmitter
Terminals, Typical Designations
S
Controller
Cable Shield
J-Box