Purus Living 800 - Tile Insert Grate - Manual (Page 8)

8 02830
PURUSLINE LIVING WETROOM SOLUTION Wooden floor
NO TE: Once installed
and the G rout is fully dr y,
check for leaks befo re using.
NOTE: Prior to tiling an unde rfloor heat-
ing mat can be laid, ensuring that the
maximum height of 13 mm is not
exceeded.
Stage 9
Tile the tray to the desired pattern, followed
by the insert cover using flexible EN12004
C2 classified tile adhesive applied using a
notched trowel in accordance with the code
of practice BS5385:2009.
Fix the tiles with adhesive that fastens to
stainless steel.
Use a small straight edge up against the
gully gap so as to prevent the tile adhesive
falling into the gully body.
Finally grout the gaps with flexible, water
proof, anti-mould grout, ensuring that no
grout falls into the gully body. Allow to dry
and settle for 48 hours.
If tile adhesive or grout falls into the gully
immediately clean it up.
The grate when installed must be horizontal
and flat. It also must be level with the ceramic
tile surface and not at an angle or on a slope.
NOTE: Once installed and the grout is fully
dry, check for leaks before using.
Fix Tiles to BS5385 Standard.
NO TE: Once installed
and the G rout is fully dr y,
check for leaks befo re using.
NOTE: Prior to tiling an unde rfloor heat-
ing mat can be laid, ensuring that the
maximum height of 13 mm is not
exceeded.
Tile
Grout
Waterproof membrane
Tile adhesive