Powertrax 9206053500 - Manual (Page 12)

10
23. Insert the driver onto the coupler
making sure the driver’s notch is
aligned with the paddle on the
block.
The driver and coupler teeth
should be fully engaged all the way
around.
Driver Notch
21. Check the gap in the differen-
tial case using the gage block.
The narrow side of the block
should fit in the gap, but the
wider side should not fit.
Go No Go
If gap is incorrect, STOP and call
Powertrax Technical Support at
864-843-9275.
There may be a
problem with your differential case.
22.
If the gap is correct, remove the
cap, gage ring, and coupler to
proceed.