Powertrax 9201202920 User Manual
Page 18
38.
Make sure pinion shaft is secure
by tapping it in both directions. The
pinion shaft should be held securely
by the half blocks.
16
37.
Push axle shafts inward
through couplers as far as they
will go. The axles should push
the thrust block halves together,
locking the pinion shaft in place.
Bolt axles back to the brake
backing plates.
Note: For disassembly, remove
the axle shafts and the springs
between the drivers. Then, insert
a narrow screwdriver or pick
between the drivers and through
the slots in the spacers to seper-
ate the two half blocks. The pin-
ion shaft may then be pushed out
of the differential.