Powertrax 9201202920 User Manual
Page 16
32.
Check the gap between
drivers using check block. The
narrow side of the block should
fit between the drivers, but the
wider side should not fit.
Go
No Go
14
pinion shaft opening
pinion shaft opening
33.
Making sure drivers stay
engaged with couplers, carefully
rotate both wheels backwards 1/4
turn to expose pinion shaft opening.
saddle springs
34.
Feel through pinion shaft open-
ing and verify both spacers and
drivers are fully seated onto cou-
plers. Verify all 8 saddle springs
are fully seated in holes and the two
half blocks are separated and
aligned to allow the pinion shaft to
enter.
If gap is incorrect, STOP and call
Powertrax Technical Support at
864-843-9275.
There may be a
problem with your differential case.