Noctua NC-U6 User Manual
Installation manual
Fixing the mounting brackets
Congratulations on your purchase of the
NC-U6
Chipset Cooler!
Please follow the instructions given in this manual in order to
install the
NC-U6
on your mainboard.
Box contents
Please choose the appropriate set of mounting brackets
according to the mounting system of your mainboard:
Caution:
Do not overtighten the screw!
Mounting brackets
for push-pin holes
Mounting brackets
for hooks
Screw the mounting brackets to the heatsink using the
supplied screw:
Screw
Spacer
Foam
Applying thermal paste
If there are traces of thermal paste or thermal pads on your
chipset, please clean them off first. Spread a thin coating of
the supplied thermal paste on the chip.
Caution:
Applying too much thermal paste will lower the
heat conductivity and cooling performance!
Should you have any questions, please consult the FAQ section on
www.noctua.at or contact us at [email protected].
Choosing the mounting brackets
NC-U6 Chipset Cooler
Installation Manual
- NH-C14 (4 pages)
- NH-D14 (4 pages)
- NH-D14 SE2011 (2 pages)
- NH-D15 (6 pages)
- NH-L12 (4 pages)
- NH-L9a (1 page)
- NH-L9i (1 page)
- NH-U12S (6 pages)
- NH-U14S (6 pages)
- NH-U9B SE2 (4 pages)
- NM-A90 Kit (1 page)
- NM-i115x Mounting-Kit (2 pages)
- NM-I2011 Mounting-Kit (1 page)
- NM-I3 Mounting-Kit (2 pages)
- NH-U12DO A3 (1 page)
- NH-U12DX i4 (2 pages)
- NH-U9DO A3 (1 page)
- NH-U9DX i4 (2 pages)
- NF-A14 FLX (2 pages)
- NF-A14 PWM (2 pages)
- NF-A14 ULN (2 pages)
- NF-A15 PWM (2 pages)
- NF-A4x10 FLX (2 pages)
- NF-A6x25 FLX (2 pages)
- NF-A9x14 PWM (2 pages)
- NF-B9 PWM (2 pages)
- NF-F12 PWM (2 pages)
- NF-P12 PWM (2 pages)
- NF-R8 PWM (2 pages)
- NF-S12A FLX (2 pages)
- NF-S12A PWM (2 pages)
- NF-S12A ULN (2 pages)
- NT-H1 (1 page)
- AM2 Upgrade-Kit (1 page)
- LGA1366 Mounting-K (1 page)
- NH-C12P (4 pages)
- NH-C12P SE14 (4 pages)
- NH-U12 (3 pages)
- NH-U12DX 1366 (1 page)
- NH-U12F (10 pages)
- NH-U12P (4 pages)
- NH-U12P SE1366 (2 pages)
- NH-U12P SE2 (4 pages)
- NH-U9B (4 pages)