Bosch 23612 - Manual (Page 9)

-9-
SWIVEL LIGHTING SYSTEM
Your tool is equipped with integrated light
source in the knurled thumbwheel. The light
will go ON as soon as you squeeze trigger
switch, unless the thumbwheel is in the 0
position (Fig. 4).
The light beam can be adjusted to 3 positions
in front of the chuck for the desired bit being
used.
Position 1: The focus of the beam is
approximately 20 mm.
Position 2: The focus of the beam is
approximately 150 mm.
Position 3: The focus of the beam is
approximately 500 mm.
Position 0: The beam is shut off permanently.
20 mm
150 mm
500 mm
2
0
1
3
RELEASING AND INSERTING
BATTERY PACK
Release battery pack from tool by pressing
on both sides of the battery release tabs and
pull downwards. Before inserting battery
pack, remove protective cap from battery
pack. To insert battery, align battery and slide
battery pack into tool until it locks into
position. Do not force (Fig. 1).
INDICATOR
LIGHT
CHARGER
BATTERY
PACK
PROTECTIVE
CAP
CHARGING BATTERY PACK (1 HOUR CHARGER)
Plug charger cord into your standard power
outlet. Before inserting battery pack, remove
protective cap, then insert battery pack into
charger (Fig. 5). The charger’s green indicator will begin to
“BLINK”. This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
FIG. 4
FIG. 5