Multiquip LT6D - Manual (Page 22)

page 22 — LT6D LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #0 (07/16/13)
components
Figure 5. Major Components (Front/ Rear)
REAR VIEW FRONT VIEW
25
29
30
24
28
33 32
29
26
34
27
31 31
24. Rear Reflectors — There are two reflectors mounted
on the rear light tower panel. These reflectors provide
better visibility in dark conditions.
25. Engine Exhaust Pipe — Directs engine exhaust to the
rear of the light tower. neveR block this exhaust pipe
with obstructions. ALWAYS place the light tower in an
area free of obstructions.
26. Right Brake Light — Before towing the light tower, make
sure that this light is operational and is working correctly.
neveR tow the light tower if this light is inoperative.
27. Left Brake Light — Before towing the light tower, make
sure that this light is operational and is working correctly.
neveR tow the light tower if this light is inoperative
28. License Light — This light illuminates the license plate.
Whenever towing of the light tower is required, make
sure this light is operational.
29. Rear Jackstands/Outriggers — There are two
jackstands located at the rear of the trailer. Use these
jackstands and outriggers to level and support the light
tower.
30. Tires — This light tower uses a ST175-80D size tire.
Replace with only recommended tire size. neveR tow
light tower with bad or worn tires.
31. Front Jackstands/Outriggers — There are two
jackstands located at the front of the trailer. Use these
jackstands and outriggers to level and support the light
tower.
32. Left-side Ballast — This area of the light tower
encloses the components for the ballast assembly
lights 1 and 3 (top).
33. Right-side Ballast — This area of the light tower
encloses the components for the ballast assembly
lights 2 and 4 (bottom).
34. Ground Point — Connect earth ground (ground rod) to
this connection point if required.