Multiquip LT6D - Manual (Page 21)

LT6D LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #0 (07/16/13) — page 21
components
Figure 4. Major Components 2 (Control Panel Side)
120/240 VAC ENGINE
HOURS OFF OFF
OFF OFF OFF
1/10
LIGHTING 120 VAC
15 14
13
17
16
18
22
20
23
16
21 19
13. Tongue Jackstand — Use this jackstand to support the
tongue when attaching the light tower to a towing vehicle.
14. safety Chain — Always attach safety chains to the
towing vehicle. neveR tow the light tower with the safety
chain unattached. Make sure safety chains are crossed
when towing.
15. Chock Blocks — Place blocks (not included as part
of the light tower package) under each trailer wheel to
prevent rolling.
16. Tie-Down Points — Used to tie down light tower with
straps or chains to allow even application of force to the
front and rear of the equipment during transport.
17. Fuel Tank/Cap — Remove cap to add No. 2 diesel fuel.
Fuel tank capacity is 34 gallons (103.6 liters).
18. engine status module — Displays engine status via
LEDs, water temperature, air filter, fuel, alternator, oil
pressure, glow plugs. Insert ignition key, turn clockwise
to start engine.
19. Control panel — Contains the auxiliary output
receptacles, engine hour meter, excitation capacitor
and circuit breakers.
20. manual Holder — Contains information regarding the
light tower.
21. Panel Light — When the cabinet door is raised, the
light will automatically turn on. When the cabinet door
is closed, the light will turn off
22. Engine — 3-cylinder, water cooled, direct injection,
12 HP diesel engine.
23. Battery — The 12-volt DC battery (CA:550/
CCA:430) is shipped wet and is ready for use.
Battery is shown here for clarity.