Multiquip DCA45SSIU3 - Manual (Page 36)

PAGE 36 — DCA45SSIU3 50 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #2 (12/19/08)
GENERATOR SHUT-DOWN PROCEDURES
NORMAL SHUTDOWN PROCEDURE
To shutdown the generator, use the following procedure:
Place both the 1. MAIN, GFCI and LOAD circuit breakers
as shown in Figure 49 to the OFF position..
Main, GFCI and Load Figure 49.
Circuit Breakers Off
Let the engine cool by running it at low speed for 3-5 2.
minutes with no load applied.
Place the ignition switch (Figure 50) in the “ 3. STOP”
position, remove the key and store in a safe place.
Ignition Switch (Normal) Figure 50.
Remove all loads from the generator. 4.
Inspect entire generator for any damage or loosening 5.
of components that may have occurred during
operation.
WARNING
NEVER stop the engine suddenly except in an
emergency.
EMERGENCY SHUTDOWN PROCEDURE
Place the 1. MAIN, GFCI and LOAD (Figure 51) circuit
breakers to “OFF” position.
Turn the ignition switch key to the “ 2. STOP” position.
Ignition Switch (Emergency) Figure 51.