Multiquip DCA25SSI2 - Manual (Page 35)

PAGE 35 — DCA-25SSI2 — PARTS AND OPERATION MANUAL—FINAL COPY (06/29/01)
Voltage Selector Switch- Single Phase 240/120V
Position
The following are additional voltages available when the
240/120V position.
Single Phase, 240 Volt
This setting can provide single phase power at 240 volts.
After hooking up the hard wires to the lugs as shown in
Figure 28, 240 volts can be obtained and using the
voltage regulator to fine tune.
Single Phase: 120 Volt
This setting can provide single phase power at 120 volts.
After hooking up the hard wires to the lugs as shown in
Figure 29, 120 volts can be obtained by using the voltage
regulator to fine tune.
Figure 27. Voltage Selector Switch 240/120V Single Phase
Position
Figure 28. Hard Wire Hookup for Single Phase 240 volt
Figure 29. Hard Wire Hookup for Single Phase, 120 volt
DCA-25SSI2 — OUTPUT VOLTAGE SETUP