Multiquip CA4HM - Manual (Page 21)

CA4HM WALK-BEHIND TROWEL — OPERATION MANUAL — REV. #3 (10/28/10) — PAGE 21
Figure 14. Throttle Lever (Run Position)
6. Grasp the starter grip (Figure 13) and slowly pull it out. The
resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.
Figure 13. Starter Grip
2. After the engine cools , turn the engine start/stop switch to the
“OFF” position (Figure 15).
Figure 15. Engine ON/OFF Switch (OFF Position)
3. Close the fuel shut- off valve (Figure 16) by moving the fuel
valve lever to the OFF position.
Figure 16. Fuel Valve Lever (OFF Position)
Stopping The Engine
1. Move the throttle lever to the IDLE or SLOW position (Figure
14) and run the engine for three minutes at low speed.
7. If the engine has started, slowly return the choke lever
(Figure 11) to the OPEN position. If the engine has not started
repeat steps 1 through 6.
8. Before the trowel is placed into operation, run the engine for
several minutes. Check for fuel leaks, and noises that would
associate with a loose V-belt cover or component.
9. To begin troweling, move the throttle lever (Figure 14) toward
the " FAST" position.
OPERATION