Multiquip HTX44K4_K5 - Manual (Page 28)

PAGE 28 — HTX-SERIES • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #2 (03/21/06)
)
1. Fuel Filter
2. Engine Stop Lever
3. Dipstick (engine oil)
4. Engine Oil Filter
5. Drain Plug (engine oil)
6. Filler Port (engine oil)
7. Crank Shaft V-pulley
8. Cooling Fan
9. Adjustment bolt (V-belt tension)
10. V-belt
11. Rocker Arm Cover
12. Fuel Injection Pump
13. Alternator
14. Starter motor
15. Flywheel
16. Air Intake Port (from air cleaner)
17. Turbocharger
18. Lifting Eyelet
19. Fuel Pump
WARNING
Accidental starts can cause severe injury
or death.
ALWAYS place the ON/OFF switch in the
OFF position.
When performing maintenance on the trowel or engine, follow
all safety messages and rules for safe operation stated at the
beginning of this manual.
Disconnect negative battery cable
from battery before servicing.
HTX-SERIES — MAINTENANCE
See the engine manual supplied with your machine for appropriate
engine maintenance schedule and troubleshooting guide for
problems.
Maintenance Schedule
Change the hydraulic oil and filter after the first 100 hours of
use, then change every 250 hours.
Daily (8-10 Hours)
1. Check fluid levels in engine and reservoir; fill as necessary.
Weekly (30-40 Hours)
2. Relube arms, thrust collar and clutch.
3. Replace blades if necessary.
4. Check, clean, or replace the engine air filter as necessary.
5. Replace engine oil and filter as necessary, see engine
manual.
Monthly (100-125 Hours)
Remove, clean, reinstall and relube the arms and thrust collar.
Adjust the blade arms.
Yearly (500-600 Hours)
1. Check and replace if necessary the arm bushings, and
thrust collar bushings.
2. Adjust blade speed.
3. Replace hydraulic fluid and hydraulic filter.
MAINTENANCE
ALWAYS allow the engine to cool before
servicing. NEVER attempt any
maintenance work on a hot! (muffler,
radiator, etc.) trowel.
1
4
9
6
3
5
2
7
8
17
19
15
18
23
20
10
18
14
13
22
21
16
12
11