Multiquip HTH44T - Manual (Page 15)

HTH44T • RIDE-ON POWER TROWEL — OPERATION & PARTS MANUAL — REV. #8 (03/27/12) — PAGE 15
— PAGE RM
HTH44T— CONTROLS AND INDICATORS
29. Retardant Spray Tank - Holds 5 gallons of retardant or
water.
30. Battery - Provides +12V DC power to the electrical
system.
31. Hydraulic Suction Filter - Filters hydraulic fluid prior to
entering the system.
32. Hydraulic Return Filter - Filters hydraulic returning to
reservoir.
33. Documentation Box - Contains information regarding
the trowel.
23. Lift Loops –Located on both the left and right sides of
the main frame. Used when the trowel must be lifted onto
a concrete slab.
24. Engine Oil Dipstick – Indicates engine oil level.
25. Engine Oil Filler Cap - Remove this cap to add engine
oil.
26. Air Filter – Prevents dirt and other debris from entering
the fuel system.
27. Oil Filter – Provides oil filtering for the engine.
28. Retardant Spray Motor – Used with the spray control
button.
Figure 3. HTH44T Controls and Indicators (Rear)
NOTE
Specification and part number
are subject to change without
notice.
Read this entire instruction manual
completely before attempting to operate this
machine.
NOTE
The following section is intended as a basic guide
to the Ride-On Power Trowel operation, and is
not to be considered a complete guide to concrete
finishing. It is strongly suggested that all operators
(experienced and novice) read “
Slabs on Grade ”
published by the American Concrete Institute,
Detroit Michigan.