Multiquip K200 - Manual (Page 13)

Wet Screed K200 — PARTS & OPERATION MANUAL — REV. #2 (03/12/01) — PAGE 13
Operation of the Electric Wet Screed
1. Check that the Wet Screed is properly assembled and
that the switch is in the ‘OFF’ position.
2. Put the plug of the drive-unit’s feeder cable in the wall
socket.
3. Place the Wet Screed in the direct vicinity of where you
are going to smooth the surface of the concrete-floor.
4. Place the Wet Screed on the surface of the freshly poured
concrete, and turn the speed regulator slowly to the
required revolutions.
5. Adjust the trowel blade angle.(read paragraph 2, on page
11)
6. Now start to smooth the surface of the concrete floor by
moving the Wet Screed backwards in a slow but steady
motion.
7. After having finished one lane of concrete, switch off the
Wet Screed immediately, by turning the speed regulator’s
knob to the position ‘Minimal’. You will hear a “CLICK”.
(Fig. 2.2, on page 11)
Tip: If the processed concrete-surface is not smooth or level
enough, repeat the procedures 5 ,6,7 and 8.
8. Pull the plug of the feeder cable out of the wall socket.
9. After use, place the Wet Screed on a dry and stable surface.
K200 — OPERATIONS
Operation of the Gas Wet Screed
a. Throttle cable
b. Spark plug
c. Overflow pipe
d. Starter rope
e. Fuel cap and fuel filter
f. Fuel tank
g. Air filter
h. Carburetor
Figure 2.3
Components of the gas-engine
Figure 2.2
Work situation during smoothing and
compacting of the concrete floor.