Multiquip EM120S - Manual (Page 27)

EM120P/S HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #5 (09/15/11) — PAGE 27
SHUT-DOWN
STOPPING THE MIXER (GASOLINE ENGINE)
1. Push the start/stop switch (Figure 29) inward to stop
the engine.
2. Place the fuel valve (Figure 30) lever to the OFF
position.
3. Clean mixer as referenced in the maintenance section
of this manual.
STOPPING THE MIXER (ELECTRIC MOTOR)
1. To stop the electric motor, press the red OFF/STOP
switch (Figure 31).
2. Disconnect the electric motor's extension cord from
its power source.
3. Clean mixer as referenced in the maintance section of
this manual.
Figure 29. Start/Stop Switch (Stop)
Figure 30. Fuel Valve Lever (Off)
CAUTION —Start/Stop Switch
NEVER disable or disconnect the start/stop switch. It is
provided for operator safety.
Serious Injury may result if
it is disabled, disconnected or improperly maintained.
OFF
STOP
ON
START
PRESS TO
STOP
Figure 31. Electric Motor On/OFF Switch (Stop)