beautypg.com

Ms15h/ms15e mixer — start-up procedures, Danger – Multiquip MS15E User Manual

Page 23

background image

MQ STOW MS15H/MS15E MIXER — PARTS & OPERATION MANUAL — REV. FINAL (08/10/06) — PAGE 23

Starting (electric only)

1.

Using an adequate size extension cord (see Table 4),
connect one end of the extension cord to the plug on the
electric motor, connect the other end to the power source.
Make sure the motor is configured for the proper operating
voltage.

2.

Set the electric motor's ON/OFF switch (Figure 5) to the
ON position.

MS15H/MS15E MIXER — START-UP PROCEDURES

4.

Turn the engine switch (Figure 12) to the ON position.

Figure 12. Engine ON/OFF Switch (ON)

7.

Pull the

starter grip

(Figure 13) lightly until you feel

resistance, then pull briskly. Return the starter grip gently.

Figure 13. Starter Grip

Be sure to stand clear of the

dump handle

when the mixer

is operational. Any binding of
material between the mixer
blades and the drum will cause
the drum handle to move to the
discharge position, thus
causing bodily harm.

Mixing Dumping

1.

The paddle shaft inside the drum should be rotating at this
time.

2.

Lift the mixing bag compound onto the steel grate over the
bag cutter and let the contents fall into the drum.

3.

Add water, and mix compound to desired consistency.

NEVER disable or disconnect the start/stop switch. It is
provided for operator safety.

Serious Injury may result

if it is disabled, disconnected or improperly maintained.

DANGER

DANGER

DANGER

DANGER

DANGER

DO NOT Disconnect

the Start/Stop Switch

Stopping the Mixer (Electric Motor)

1.

Place the electric motor's

ON/OFF switch in the OFF

position.

2.

Disconnect the electric motor's extension cord from its
power source.

3.

Clean drum of all debris and foreign matter.

4.

Store mixer in a clean dry location.

NOTE

Stopping the Mixer (Electric Motor)

1.

Place the engine

ON/OFF switch (Figure 14) in the

OFF position.

2.

Place the fuel shut-off valve in the OFF position.

3.

Disconnect the spark plug wire.

4.

Clean drum of all debris and foreign matter.

5.

Store mixer in a clean dry location.

Figure 14. Engine ON/OFF Switch (OFF)

This manual is related to the following products: