Multiquip MS15E - Manual (Page 15)

MQ STOW MS15H/MS15E MIXER — PARTS & OPERATION MANUAL — REV. FINAL (08/10/06) — PAGE 15
MS15H/MS15E MIXER — MIXER COMPONENTS
Figure 3. Mixer Components
Figure 3 illustrates the basic components and controls of
the MS15H/MS15E mixer.
1. Engine Cover — Lift this cover to gain access to the engine
compartment.
2. ON/OFF Switch (electric) — This switch is provided on
mixers with electric motors. To gain access to this switch,
lift the engine cover. When activated it will shut down the
electric motor.
3. Bag Cutter— This feature allows compound mixing bags
to be opened easily, therefore allowing the contents of the
bag to fall directly into the mixing drum.
4. Safety Grill — Provided for operator safety. This safety
grill is designed to keep hands and solid objects out of the
mixing drum when in use. This grill should be closed at all
times when mixer is in use. DO NOT remove the grill or
grill opening bar. Keep the grill clean by washing it down
daily.
5. Dump Handle — Pull this handle downward to dump the
contents of the drum. Push the handle upward to return
the drum to its vertical position.
6. Pivot Point/Zerk Fitting — There is, on each end of the
mixing drum a zerk grease fitting. These fittings lubricate
the dumping mechanism. Lubricate both fittings at least
twice a week.
7. Steel Mixing Drum — Mixing materials such as mortar,
plaster are to be placed into this drum for mixing. Always
clean the drum after each use.
8. Chock Blocks — Place these blocks (not included as
part of the mixer package) under each mixer wheel to
prevent rolling.
9. Mixing Paddles — Used in the mixing of material. This
unit uses four different types of paddles to provide a fast
uniform mix.
10. Tires — Replace tires with the recommended type tire of
12 x 3.