Multiquip MQD306 - Manual (Page 17)

MQ-D305/D306 SERIES DIAPHRAGM PUMP S— PARTS MANUAL— REV. #2 (08/24/05) — PAGE 17
Gear Reduction Oil (Transmission)
1. Remove the transmission oil level plug (Figure 6). If oil
begins to seep out as the plug is being removed, then it
can be assumed that the transmission oil is at the proper
operating level.
2. If oil does not seep out as the oil level plug is being removed,
then remove the transmission oil fill plug and fill with
SAE 80/90
EP gear oil to the proper operating level.
Transmission oil capacity is capacity is 1-1/4 pints (590 ml.).
MQ-D305/D306 SERIES— PRE-SETUP (PUMP)
Connecting Rod Bearing Lubrication
1. Grease connecting rod bearing thru the access
hole (Figure 7) every 25 hours of operation.
2. Use only premium lithium based grease , conforming to
NLG1 Grade #2 consistency.
Figure 6. Transmission Oil Level Figure 7. Connecting Rod Bearing Lubrication
NOTE
Diaphragm pumps will handle fluids
containing considerable solids (not to
exceed 1.5 inch/28 mm), however, if
the mixture is too heavy to be pumped,
water must be added until the mixture
becomes sufficiently fluid for pumping.