Multiquip MVH120VGH - Manual (Page 22)

PAGE 22 — MVH120VGH PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #2 (09/22/08)
MAINTENANCE
HYDRAULIC OIL
Check hydraulic oil in every 100 hours of operation. With
handle bar positioned vertically (storage position), remove
breather plug (Figure 1) off the top of hydraulic pump and
check for proper oil level.
Replace hydraulic oil after first 200 hours and in every 1,000
hours of operation.
Replacing Hydraulic Oil
1. After removing plug cap of hand pump (Figure 7),
remove plug of breather (24 mm wrench) and disconnect
vibrator side of hydraulic hose (Figure 18) at vibrator
cylinder. With travel lever placed in the
FORWARD
position, drain hydraulic oil in the pump.
2. After draining, reconnect the hydraulic hose to vibrator.
3. Fill oil through breather hole of hand pump. (capacity:
about 300 cc). Use Shell Tellus Oil #46 or equivalent.
4. Removing breather plug at vibrator cylinder causes oil
to flow out of breather hole in a while. When aeration
disappears, replace the plug and tighten securely.
5. Replace breather plug of hand pump and fit the plug
cap. After making sure that oil in pump is at proper
level, replace the breather plug.
Make sure hydraulic oil in hand pump is at a normal
save operating level. DO NOT over fill. Over filling
(excessive oil) will cause excess oil to blow out of
breather plug.
CAUTION
Figure 18. Hydraulic Hose
STORAGE
For storage of the pump for over 30 days, the following is
required:
„ Drain the fuel tank completely.
„ Run the engine until the fuel in the injection system is
completely consumed.
„ Completely drain the oil from the engine crankcase and
follow procedures described in the HONDA engine
Owner's Manual for engine storage.
„ Completely drain the compactor's hydraulic oil from the
vibrating case.
„ Clean entire plate compactor, especially the bottom plate,
removing all dirt and foreign matter.
„ Cover plate compactor and engine with plastic covering
or equivalent and store in a clean, dry place.