beautypg.com

Basic engine – Multiquip MTR40SF User Manual

Page 13

background image

MTX40sf RaMMeR • opeRaTion and paRTs Manual — Rev. #0 (11/28/12) — page 13

BasiC engine

Figure 2. Robin Engine

The engine (Figure 2) must be checked for proper

lubrication and filled with fuel prior to operation. Refer

to the manufacturer's engine manual for instructions and

details of operation and servicing.
1.

secondary air Cleaner — Prevents dirt and other

debris from entering the fuel system. Remove wing-

nut on top of air filter cannister to gain access to filter

element.

2.

Choke lever — Used when starting the engine.

Normally used in cold weather conditions. In cold

weather turn the choke lever to the fully closed

position, in warm weather set choke lever half way or

completely open.

3.

spark plug — Provides spark to the ignition system.

Set spark plug gap to 0.02 - 0.03 inch (0.6 - 0.7 mm).

Clean spark plug once a week.

4.

engine on/off switch — Controls the starting and

stopping of the engine. Switch must be in the "ON"

position when starting the engine.

5.

Recoil starter (pull rope) — Manual-starting method.

Pull the starter grip until resistance is felt, then pull

briskly and smoothly.

6.

Muffler — Used to reduce noise and emissions.

NOTICE

Operating the engine without an air filter, with a

damaged air filter, or a filter in need of replacement

will allow dirt to enter the engine, causing rapid engine

wear.

WaRning

Engine components can generate

extreme heat. To prevent burns,

do

noT touch these areas while the

engine is running or immediately

after operating.

neveR operate the

engine with the muffler removed.