Multiquip MT65H - Manual (Page 17)

MT-65H — OPERATION & PARTS MANUAL — REV. #4 (06/30/05) — PAGE 17
Operation
1. To start the rammer tamping action, move the throttle lever
(Figure 9) quickly from IDLE (close) to the FULL OPEN
position . DO NOT move the throttle lever slowly as this may
cause damage to the clutch or spring.
Stopping The Engine
Normal Shutdown
1. Move throttle lever quickly from the FULL OPEN to IDLE
position (Figure 10) and run the engine for three minutes at
low speed. After the engine
cools , turn the engine start/stop
switch to the “STOP” position (Figure 11).
MT-65H — OPERATION
Make sure that the throttle lever is moved to the FULL OPEN
position. Operating the rammer at less than full speeds can
result in damage to the clutch springs or foot.
2. The MT-65H Tamping rammer is designed to run at 3,600
rpm. At optimum rpm the foot hits at the rate between 590 ~
695 impacts per minute. Increasing throttle speed past
factory set rpm does not increase impacts and may damage
unit. The MT-65H is designed to advance while tamping. For
faster advance, pull back slightly on the handle so that rear
of foot contacts soil first.
3. To stop the tamping action, move throttle lever quickly from
the FULL OPEN to IDLE position.
Figure 10. Throttle Lever (Idle)
Figure 9. Throttle Lever (Full Open)
Figure 11. ON/OFF Switch (Off Position)
2. Close the fuel shut- off valve (Figure 12) by moving the fuel
cock lever to the CLOSED position.
Emergency Showdown
1. Move the throttle lever quickly to the IDLE position, and turn
the engine start/stop switch to the STOP position.
Figure 12. Fuel Shut-OFF Valve (Off Position)
CAUTI CAUTI CAUTI CAUTI CAUTION