Purenex Multipure Aquaversa - Manual (Page 8)

Congratulations, your Drinking water system has been connected to your faucet and you are now ready to start-up the
unit, as follows:
1. using a paper towel or cloth, dry off all connections.
2. also, dry off the drinking water unit.
3. ensure that all connections are tight (CauTIOn: DO nOT OVer TIGHTen).
4. Turn on the water.
5. Push the bypass lever of the diverter valve to start the flow of water through the unit.
6. allow the water to run through the unit spout for about 5 minutes (10 minutes for MP880sC) so that all air can
escape.
7. Push the bypass lever of the diverter valve to shutoff the flow of water through the Drinking water system. Then turn
off the faucet to stop the flow of water at your sink.
8. Check all connections to confirm that there are no leaks.
9. allow water to run through the unit to waste for approximately 20 minutes (30 minutes for MP880sC) to flush the filter
and charge the carbon.
10. Push the bypass lever of the diverter valve to shutoff the flow of water through the Drinking water system. Then shut
off the water at your faucet and check for leaks.
Congratulations, you have completed the installation.
For optimum performance and to maintain the warranty on your Multipure Drinking water system, it is recommended that
your filter be replaced on a regular basis. Filter life will vary depending on amount of water used and the type and level of
contaminants in your local water.
If you have any questions regarding the installation of your
countertop unit, call:
Multipure Corporation
Customer Relations Department
7251 Cathedral Rock Drive
Las Vegas, NV 89128
702.360.8880 phone
800.622.9206 toll-free
702.360.8575 fax
email: [email protected]
www.multipure.com
bypass
lever
8
V. Start-up and Use of Your Countertop Drinking Water System