Purenex Multipure Aquaversa for model MP750SB - Manual (Page 3)

MP750Series
Model Numbers MP750SB, MP750SI, MP1200EL*
Approximate Filter Capacity 750 gallons
Capacity with End-of-life Indicator 1200 gallons
Replacement Filter Type CB6
Approximate Filter Cost $60.00 +
Approximate Flow Rate @ 60 psi 0.75 gpm
Housing Composition Stainless Steel
Rubber Items Nitrile (NBR)
Outlet 1/4" tube x 1/8" Pipe
Inlet 3/8" tube x 1/8" Pipe
Maximum Working Pressure 100 psi/ 7.0 kg/cm²
Minimum Working Pressure 30 psi/ 2.1 kg/cm²
Maximum Operating Temperature 100° F/38°C - for cold water use only
Minimum Operating Temperature 32°F/0°C - for cold water use only
Particle Retention Size sub micron (0.5 micron)
Certified by: NSF
+ plus tax and shipping and handling
* model comes with end-of-life indicator
N O T E S
1. Replacement filters can be purchased directly from Multi-Pure Corporation. The replacement filter model number is CB6.
The approximate retail price of the replacement filter is also shown above. Price excludes sales tax and shipping and
handling fees (prices subject to change without notice).
2. Filter life will vary in proportion to the amount of water used and the level of impurities in the water being processed.
Replace the filter cartridge when the first of the following occurs: (a) annually; (b) when the unit's rated capacity is
reached; (c) the flow rate diminishes; (d) the filter becomes saturated with bad tastes and odors. The rated capacity of the
filter cartridge is 750 gallons for Models MP750SB and MP750SI; capacity of the MP1200EL is 1200 gallons.
3. MP1200EL comes with a capacity monitor that automatically flashes a yellow light when it is time to replace the filter.
4. Not intended to be used where the water is microbiologically unsafe or with water of unknown quality without adequate
disinfection before or after the unit. Systems certified for cyst reduction may be used on disinfected waters that may con-
tain filterable cysts.
5. Do not allow water to freeze in the unit. If unit is exposed to freezing temperatures, drain water from unit and remove filter.
6. Do not allow water to sit in unit for extended periods of time (10 or more days) without being used. If unit is to be left unused
for more than 10 days, drain all water from the system and remove the filter. Upon your return, reconnect the filter in the
housing and continue use. In the event water does sit in the unit for 10 or more days, the system should be flushed by
allowing water to flow to waste for about 3 minutes; then continue use as normal.
7. To dispose of the used filter, remove it from the housing and place the old filter in your normal refuse. The filter disposed of
in a normal landfill will not release any chemical contamination but will probably continue to adsorb additional contaminants
that are disposed of in landfills.
8. Check for compliance with state and local laws and regulations.
3
Operation and Maintenance Specifications I.A.