MTD 190-751-OEM User Manual

Page 6

1. Check the area of operation thoroughly before

using the tractor with the snow cab. The added
height of the snow cab and a reduced field of vision
require extra caution during operation.

2. Enter the snow cab on the left side at the rear.

Unfasten the elastic hook at the bottom and the
velcro fastener in the top in the rear corner.

3. Operate outside controls on a snowthrower or snow

blade through the access flaps in the sides of the
canopy.

4. Remove the upper snow cab frame and canopy

before you transport the tractor in an open truck or
open trailer.

CAUTION: Watch out

for low tree

limbs and other overhead objects which
may interfere with the snow cab.

CAUTION: Never

transport the tractor in

an open truck or open trailer while the
snow cab is attached.

CAUTION:

This cab provides foul

weather protection only. It does not
provide protection against exhaust fumes,
collision, rollover or other accidents.

17. Assemble two spiral hooks into holes on top of u-tube

at front of tubing frame. See figure 9.

18. Insert ends of rope down through spiral hooks

attached to u-tube and then insert ends through two
grommets in front of canopy. See figure 9.

FIGURE 9

19. Insert one end of rope through a third spiral hook and

tie a knot in end of rope. See figure 10.

20. Assemble spiral hook with rope attached through

hole in footrest clamp. See figure 10.

21. Insert other end of rope through remaining spiral

hook. Tie a knot in end of rope so that when hooked
to other footrest clamp the rope is tight and canopy
frame is stable. See figure 10.

FIGURE 10

OPERATING THE SNOW CAB

Read this owner's manual and safety rules before
operating your tractor with the Snow Cab.

MAINTENANCE

1. Before each use make a thorough visual check of

the snow cab for any bolts and nuts which may
have loosened. Retighten any loose bolts and nuts.

2. The vinyl portion of the canopy can be washed

using water only, or a mild liquid soap and water.

3. The plastic windows should only be washed using

running water, or a mild liquid soap and water.
Wash the windows with your bare hands only. A
cloth, sponge or brush will scratch the clear plastic.

IMPORTANT:

Never clean the windows when the

plastic is dry. The clear plastic will scratch.

4. Clean the vinyl canopy thoroughly and allow to dry

before storing. Refer to the Cleaning section.

5 . Store the snow cab in a clean, dry area away from

direct sun light.

ROPE

SPIRAL HOOKS

GROMMETS

ROPE

FOOTREST CLAMP

SPIRAL HOOK