Behringer TRUTH B2031P - Manual (Page 5)

5
TRUTH B2030P/B2031P
3. APPLICATION
1.1 Before you get started
1.1.1 Shipment
The B2030P/B2031P were carefully packed at the factory to
assure secure transport. Should the condition of the cardboard
box suggest that damage may have taken place, please inspect
the unit immediately and look for physical indications of damage.
+
Damaged units should NEVER be sent directly to us.
Please inform the dealer from whom you acquired
the unit immediately as well as the transportation
company from which you took delivery of the unit.
Otherwise, all claims for replacement/repair may
be rendered invalid.
1.1.2 Initial operation
The TRUTHs must be placed on a flat and stable surface.
1.1.3 Warranty
Please take a few minutes and send us the completely filled
out warranty card within 14 days of the date of purchase. You
may also register online at www.behringer.com. The serial number
needed for the registration is located on the rear of the unit.
Failure to register your product may void future warranty claims.
2. CONTROL ELEMENTS
The control elements described in the following are the same
on both speakers.
Fig. 2.1: Rear panel connectors
This is the terminal clamp for the minus cord of your speaker
cable.
This is the terminal clamp for the plus cord of your speaker
cable.
The connection terminal of your TRUTH is recessed. This way,
you can place it in the vicinity of walls.
+
Always power down your amp before connecting it
to the TRUTH.
SERIAL NUBMER. Please take a few minutes and send to
us a completely filled out warranty card within 14 days of
the original date of purchase. Otherwise, warranty claims
may be rendered invalid. Or fill out the warranty information
online at www.behringer.com.
3. APPLICATION
3.1 Connection
Fig. 3.1: Connecting an amplifier
Please follow these steps to connect your TRUTHs to a power
amp: Loosen the plus screw (red ring with a “+”) and the minus
screw (black ring with a “-”). Now insert the plus cord of the
speaker cable connecting the amp to your TRUTH into the plus
opening. Then, connect the minus cable into the minus opening.
Tighten the screws. Do the same to connect the other TRUTH.
+
Make sure that all connections are done properly.
Speaker cables are color-coded to help avoid
confusion. You’ll know that the signal is inverted
(i.e. you’ve mixed up the connections) when you
notice that bass frequencies are getting lost and
when the stereo characteristic of the signal is
majorly worse.
+
Always make sure that bare wire ends never touch
the open end of another speaker cable, speaker
connectors or metal parts of your amp.