MotorGuide X3-40 - Manual (Page 31)

MAINTENANCE
eng
27
IMPORTANT: Read the safety and maintenance instructions which accompany your
battery.
1. Ensure that the battery is secured to the vessel.
2. Ensure that the battery cable terminals are clean, tight, and correctly installed.
For installation instructions, refer to Battery Connection.
3. Ensure that the battery is equipped with a battery box to prevent accidental
shorting of the battery terminals.
Propeller Replacement
!
WARNING
Performing service or maintenance without first disconnecting the battery can
cause product damage, personal injury, or death due to fire, explosion, electrical
shock, or unexpected motor starting. Always disconnect the battery cables from the
battery before maintaining, servicing, installing, or removing motor components.
REMOVING THE PROPELLER
1. Disconnect the power cables from the battery.
2. While holding the propeller blade with one gloved hand, use a 9/16 in. wrench
or a ratchet and a 9/16 in. socket to remove the propeller nut. Remove the
propeller nut and washer (or anode, for saltwater models).
IMPORTANT: Remove the propeller nut with a wrench or a ratchet and socket.
Using another tool may damage the propeller nut or shaft. If the propeller cannot be
removed easily, use a rubber mallet to lightly tap the back side of the opposite
blade. If the propeller cannot be removed, have the propeller removed by an
authorized dealer.
NOTE: If the propeller pin is bent, replace the propeller pin.
53442
44663