MK Diamond MK-2000P - Manual (Page 8)

8
General Specifications
Motor 120V 15 Amp (Electronic torque limitation)
Watts 1500
Speed 2 speed
Bit Capacity 1-1/2” (38mm) hand-held
4” (102mm) rig mounted
Connecting Threads 1-14” - 7” UNC
5/8” - 11 UNC
Weight 15 lbs. (6.8 kg)
Includes • Quick Release Water Valve
• GFCI
• Plastic Carrying Case
Part # 158365
PRODUCT SPECIFICATIONS
ON/OFF SWITCH
OPERATING THE MK-2000P
Ideal for drilling holes in floors, walls, ceilings and for all concrete anchoring systems. Fast and effi-
cient drilling of reinforced concrete, concrete, brick, block and stone.
The MK-2000P is equipped with an electronic ON/OFF switch.
Each time the switch is pressed, the speed of the drill becomes higher. This allows very precise drill-
ing. Under normal working conditions, always operate the MK-2000P at maximum speed.
In hand held drilling operations, only use the MK-2000P with the Auxiliary Handle fixed. The Auxiliary
Handle must be tightened on the collar, by turning the lever.
Auxiliary Handle
5. Use only extension cords and plugs approved for outdoor work.
6. Before starting your work, check that the Ground Fault Circuit Interrupter (GFCI) is functioning
properly by pressing the test button. The GFCI must never lay in the water.
7. Don’t use the machine if a part of the housing is damaged or in case of damages on the switch,
cable or plug (check it every day).
8. Stop working if water is dripping out of the overrunning bore hole and take the machine to an
authorized service center.
9. Overhead-drilling should be done with using suitable safety measures (water collection).
10. When using the machine with manual control always hold it with both hands and take up a safe
position. Pay attention to the reaction torque of the machine.
MK-2000P PRODUCT SPECIFICATION