MK Diamond MK-2000P - Manual (Page 7)

7
SAFETY INSTRUCTIONS
1. Working safely with the MK-2000P is only possible if you read this operating instruction
completely and strictly follow the instructions contained within.
2. When drilling through ceilings or walls, make sure you will not cut through electrical wiring, gas
lines or water pipes. Use metal detection systems if needed.
3. Check the MK-2000P for damage prior to use. Inspect the cord and plug for cuts, frays and
damage. Have damage repaired by authorized repair technicians. Take care that the ON/OFF
switch is in the OFF position before inserting the plug into a power receptacle.
4. When using the drill, cooling water is not allowed to get into the motor or any electrical parts.
MK-2000P SAFETY
SAFETY LABELS
Safety labels contain important safety information. Please read the information contained on each
safety label. These labels are considered a permanent part of your drill. If a label comes off or
becomes hard to read, contact MK Diamond or your dealer for a replacement.