MK Diamond MK-100 Tracker - Manual (Page 10)

MK-100 TRACKER Revision 02/03, Effective Date February 12, 2003 Page 10
SAFETY
PRODUCT SPECIFICATIONS:
The MK-100 TRACKER is a versatile Tile Saw. Operated and used according to this manual, the MK-100
TRACKER will provide years of dependable service.
General Description:
The MK-100 TRACKER Tile Saw is engineered as a tabletop or stand mounted wet tile saw. The saw
includes a powerful 115v totally enclosed capacitor start GE motor with a thermal protective overload. The
saw is capable of cutting tile up to twenty (20) inches in length, or diagonal cutting tile up to fourteen (14)
inches. The saw can cut an object three and one-half (3-1/2) inches thick in one pass.
Motor Specifications:
Motor specifications for the MK-100 TRACKER are listed in Table 2 below.
Voltage 115 v
Overall Amperage 13.4 a
Motor Only Amperage 12.8 a
Frequency 60 Hz
RPM 3450 rpm
Horse Power 1.5 hp
Weight 97 lbs
Table 2
Thermal Overload Protection:
The motor is protected by a thermal overload equipped with a manual reset.
Blade Capacity:
The MK-100 TRACKER uses a ten (10) inch (254mm) diameter, wet cutting continuous rim, MK Diamond
blade with a one-sixteenth 1/16 inch (15.875 mm) cutting width and a five-eighths (5/8) inch (15.875 mm)
arbor.
Tile Types:
The MK-100 TRACKER can cut a variety of tile types including Porcelain, Terracotta, Marble, Quarry and
Slate, or almost any other non-ferrous material.
NOTE:
The MK-100 TRACKER is not designed to cut plastic or ferrous (metals) material.