MK Diamond MK-101 Lowes - Manual (Page 29)

29
CleaNUP
If an external water source was used, steps A through C may be skipped.
Dispose of waste water in accordance with applicable Federal, State and Local laws.
(A)
Clean the Water Pump suc-
tion of all debris. Refer to
water pump manual.
NOTe:
(B)
Place the Water Pump in an
external container
(C)
Run the MK-101 until clear
water is seen at the blade
cooling ports (Approx. 1 min.)
(D)
Remove the Water Basin and
clean.
(E)
Clean the Movable Cut-
ting Table Roller Wheel and
Frame Support
(F)
Clean the remainder of the
MK-101
MK-101 aDJUSTMeNT
(A)
Check and adjust V-belt
tension following first 48 hours of
operation (See V-belt Inspection).
MaiNTeNaNCe
Perform the following after initial purchase and operation of the MK-101.