beautypg.com

Mayline Single Starter User Manual

Page 4

background image

4.

Install screws (E3) to the inside of leg (the side opposite gusset

flange), leaving approximately 1/8" between screw head and leg tube.
5.

Using slots in trough sides (4, 5), hook trough sides onto screw

heads on both legs. DO NOT TIGHTEN SCREWS.

NOTE: If installing a table without access panels (8),
proceed to Step 7.

6.

Attach mounting angles (E11) to beam (3) using

screws (E12)
7.

Install beam (3) from rear, sliding onto legs.

Secure beam (3) with screws (E3) and washers (E4).
8.

Insert bushing (E9) into trough side (4).

9.

Tighten all screws (E3) at this time.

OR ADDER LEG, IF

REQUIRED

(4)

GUSSET FLANGE

(Starter leg only)

ADDER LEG

IF REQUIRED