beautypg.com

Mayline CSII Overhead w/Flipper Door User Manual

Page 4

background image

11. Gently lay the Door (7) onto the Top of the assembly

with the slide pulled toward the front edge of the Top. Align
the holes in the Hinged Slide with the holes in the Top.
Attach each slide with three Screws (E2). Close the door

and check for gap alignment and adjust if required. Repeat
this procedure for the second door if your overhead is so
equipped.

12. If your Overhead is to be equipped with the 'OPTIONAL'

Tack Panel, install it at this time. Please refer to the

installation instructions included with that product.

13. Remove the protective film from the Tape located on the

bottom of each end panel. Align the Overhead with the edge

of the work surface it is to be placed on and set it in position.

MAYLINE recommends that a minimum of two people
perform this task.

(4)