Mayline CSII Overhead w/Flipper Door User Manual

Page 2

4. Place the Top (1) in a vertical position with the

hinge holes 'UP'. Align the open slots in the Top

flanges with the screws in the Sides and engage the
screws. Allow the rear flange of the Top to rest onto
the Back. DO NOT tighten screws at this time.

1/8" gap - these 4 screws

1. Place the Back (2) onto a clean, protected surface.

Position the Back with the flanges upward, the larger

flange to the bottom and the smaller one to the top.

2. Place the R.H. Side (4) and the L.H. Side (5) in a
vertical position along side the Back with the holes to the

inside. Locate these holes toward the top of the
assembly. Secure each Side to the Back with two
Screws (E1). DO NOT tighten at this time.

3. Start four Screws (E1) into the holes in each Side.
Leave approximately 1/8 inch gap between screw head
and panel.

Hinge holes 'UP'

Do Not Tighten

these screws

Larger Flange

(2)

Lock 'UP'

5. Insert the Bottom (3) vertically into the assembly

with the Lock 'UP'. Align the open slot in the Bottom
flanges with the screws in the Sides and engage the
screws. The lower Back flange must capture the
flange on the Bottom panel.

6. Tighten all screws in the Back, Top, and Bottom.

7. Remove the protective backing from one side of the
Tape Strip (E3) and apply a strip to the bottom of each
end panel.

8. Stand the assembled body in an upright position.
MAYLINE recommends that a minimum of two people
perform this task.