Mayline CSII Return User Manual

Page 2

(2)

Drawer Pedestal Assembly:

1. Remove the Pedestal (4) from carton.

2. Remove all drawers from the Pedestal by pulling drawers out to the
full extent. Locate the drawer slide release tab on each drawer slide.

Press DOWN on the Right tab and LIFT the Left tab. Pull drawer forward

to remove.

3. Turn the Pedestal upside down and install four Glides into threaded
holes on bottom of Pedestal.

Return Assembly:

NOTE: Size and accessories may vary but assembly procedure remains the same. Return with Pedestal
positioned on the left side is shown.

4. Place the Work Surface (1) face down onto a clean, protected surface.

5. Position Leg (3) approximately 3/16 from the edges and align the holes in the Leg with the pre-drilled holes in
the Work Surface. Attach the Leg to the Work Surface with seven Screws (E1). DO NOT tighten screws at this
time.

For units equipped with a Drawer Pedestal (4):

Position Drawer Pedestal (4) approximately 3/16 from the edges and align the Pedestal holes with the pre-drilled
holes in the Work Surface (NOTE: DO NOT USE keyhole slots). Attach the Pedestal to Work Surface with four

Screws (E1). DO NOT tighten screws at this time.

6. Modesty Panel (2) will be positioned flush with the Leg or Drawer Pedestal. Position the Modesty Panel (2)
next to the Leg (3) or Pedestal. Align the holes in the Panel with the pre-drilled holes in the Work Surface.
Secure Panel with Screws (E1). DO NOT tighten screws at this time.

7. Attach the Modesty Panel (2) to the Leg (3) with three Screws (E2) and three KEPS Nuts (E3). Modesty

Panel does not get attached to the Pedestal Unit.

8. The Gusset (5) MUST BE postioned along side the Leg (3) or Drawer Pedestal (4) in this assembly. Align the
holes in the Gusset (5) and the holes in the Modesty Panel (2). Attach the Gusset to the Panel with two Screws
(E2) and two KEPS Nuts (E3). Attach the Gusset to the Work Surface with two Screws (E1).

9. Tighten all screws at this time.

10. Install two Glides (E5) into the Leg if your assembly is so equipped.

Pedestal
Glide