Mayline CSII Bridge - Manual (Page 2)

1. Locate the pre-drilled Connector Plate holes on the underside of the Main work surface and on the adjacent work
surface which are to be joined by the Bridge. Attach the four Connector Plates (2) to these work surfaces with four
Screws (E1) per plate. DO NOT tighten the screws at this time.
2. Place the Main work surface at the location where it will be utilized. Place the adjacent work surface at the
appropriate distance from the Main work surface.
3. Lay the Bridge Work Surface (1) onto the four connector plates. Align the edge of the Bridge with the edges of
the Main work surface and attach the Bridge with four Screws (E1) per plate. TIGHTEN these screws at this time.
4. Adjust the adjacent work surface position so that the edges align with those of the Bridge. Attach the Bridge to
these plates with four Screws (E1) per plate. TIGHTEN all screws for the Bridge and Plates at this time.
5. Two Cable Clamps are included to position cables away from work area. Attach the clamps to the Work Surface
with one Screw (E1) per clamp.
NOTE: DO NOT MOVE work station once the Bridge has been attached.
ASSEMBLY PROCEDURE: Bridge without Modesty Panel
(2)