Mayline E-Series - Manual (Page 2)

Top Plate (3)
Column (2)
FRONT
MOUNTING TOP PLATE to COLUMN
MOUNTING BASE LEGS to COLUMN
1. Place Column Assembly (2) on end with Power Cord up.
2. Turn the Base Legs (1) upside-down and position the
front of the base legs toward the front of the column.
3. Carefully feed Power Cord through center opening in the
base and through center opening in bottom.
4. Position large opening in base over column and lower
into place. NOTE: Do Not pinch Power Cord.
5. Fasten base with four 1/4-20 x 1 3/4 Hex Head Screw (E3)
and four 1/4 Lock Washer (E4).
6. Install Glides (E2) into Base Legs.
Switch Assembly (E1)
Base Legs (1)
Glide (E2)
Hex Head Screw (E3)
Lock Washer (E4)
(2)
7. Turn Column/Base upright and install Top Plate (3).
8. Place Top Plate (3) in a front biased position. (See
"Position of Top Plate" next page) Secure with four 1/4-28
x
1/2 Screws (E5) and four 1/4 Lock Washers (E4).
9. Connect Switch Assembly (E1) to Wiring Harness
extending from the Column side.