Mayline Dual Adjustable Rack - Manual (Page 2)

(2)
2. Attach Base Angle Weldment (1) to Rack
Mount Rail (2) using Screws (E1), Washers
(E2), and Nuts (E3). See Fig. 2
NOTE: Base Angle Weldment (1) installs as
shown to reduce foot print. Angle may be
installed in opposite direction to have mounting
holes for anchoring on outside of frame.
3. Repeat steps 1 and 2 for opposite side of
rack.
4. Attach Short Adjustable Channel (3) and
Frame Assembly to desired depth using
Screws (E5) and Nuts (E6). See Fig. 3 and 3A
Fig. 3A
Fig. 2
(Adjusting Rack after assembly)
5. To adjust depth of Dual Rack, remove
Screws (E5), Nuts (E6), and Short Channel (3).
Reinstall at desired depth. See Fig. 3 and 3A
Fig. 3