Mayline SRFC3871 - Manual (Page 4)

8. Upper Level: Place a corrugated insert (with
notch at the bottom front) into a corrugated
divider. Fold small flaps at bottom of divider
outwards. Install corrugated dividers (6 in all),
making sure the folded flaps fit under bottom
shelf, and top of divider fits into slots in header
panel. Press divider down firmly until flush with
shelves.
Lower Level: Place corrugated insert into
corrugated divider. Then install corrugated
dividers (3 in all) into slots in shelves in lower
level, pressing down firmly until flush with
shelves.
9. Install plastic strips on front edge of each shelf,
with the short edge of the plastic strip under the
bottom, and the longer edge over the shelf top.
Roll each strip onto the shelf edge and press
firmly into place. Repeat for all shelves.
10. The grooves in the front of each plastic strip
hold the paper labels provided. Separate each
label along the perforations; then insert in the
bottom groove, and push the label into place,
tucking the top of label into the top groove with
your fingernail. (Labels can be created using a
PC and printer or typewriter as desired, but
before separating.)