Mayline SRF3871 - Manual (Page 2)

1. Tools required: Phillips screwdriver. Unpack
carton; then identify and count all parts.
2. Place a 2" thick shelf with open side down on
the floor; front edge has slots at each end . Install
lower outside end panels (1/16" thinner than
upper outside end panels): insert tab through slot
in front as shown, and turn back of end panel
until it fits behind back of shelf. Repeat with other
side. Insert 4 screws through outside end panel
and shelf at rear corners; fasten securely.
3. Install top 2" thick shelf by sliding onto tabs of
outside end panels. Pull out the back edges of
the outside end panels so the shelf can be
lowered into place; then return outside end
panels to their original position.
4. Assemble upper level by installing upper
outside end panel. Insert tab at bottom front of
panel into same shelf slot used by lower outer
end panel; then move back of upper end panel
until it fits behind back of shelf. Now insert two
screws; repeat with opposite panel. Install top
shelf as before; insert 4 screws (through spacers
for added depth and better fit); fasten securely.