Mayline SR2446R - Manual (Page 4)

8. To install dividers, insert a divider through each slot. Dividers slide down through slots in all
shelves until they rest on the bottom shelf. Note: the end of each divider with the two holes should
be facing up.
9. When all the dividers are in place, pull each one forward to lock into position. Insert the plastic
buttons into the holes behind the dividers on the top and bottom shelves with divider slots.
10. Repeat steps #7, #8 and #9 to create the second tier of pockets in the sorter. (Start by installing
the top shelf of the first tier, which has no divider slots and a 1" front flange; this also acts as the
bottom shelf for the second tier.)
11. Position the top shelf (1" front flange and
no divider slots) over the top row of tabs on
the back panel and with its tabs through the
loops on the inside end panel, and set it
carefully in place.
12. Remove backing from double-faced tape
previously attached to bottom of sorter and
set in place. Tape will prevent sorter from
moving on table.