beautypg.com

Mayline SR2446R User Manual

Page 2

background image

1. No tools required: Unpack carton and identify all parts. Peel off protective film from face side of all

flat steel parts.

2. Position the two outside end panels (flange side up) and the back panel (tab side up) as shown
on a clean, flat, smooth surface.

3. Lift up one side of the back panel and insert tabs through the slots in the adjacent end panel.

Repeat with other side.

4. Place each of the inside end panels inside the outside end panels, loop side up; the offset lip fits

under the flange on the outer edge of the outside end panel. Note: the flange on the inside end
panel with the two holes should be facing down.