Marshalltown 59016A Mixer - Manual (Page 6)

5
3-LUBRICATION & STORAGE
Each day before operating, lubricate at the following points:
Engine/Motor – Refer to engine/motor operating instructions for all maintenance and
lubrication instructions and requirements.
GREASE FITTINGS:
Refer to Fig. 2
Clean off grease fitting before greasing. Use pressure type grease gun. Grease lightly
with general purpose grease (2 to 3 pumps).
§ Drum Shaft Bearings (where used)
§ Drive shaft Bearings
§ Tilt Wheel Shaft Bearings (where used)
§ Brake Lever Shaft (where used)
OIL:
Refer to Fig. 2
Use SAE 30 engine oil.
§ Yoke Tilt Mechanism
STORAGE
For short term storage, clean the mixer and store in a dry place. If the mixer is not to
be used for an extended period of time, service mixer completely and store it in a dry
place.
1. Refer to motor/engine instructions for storage instructions.
2. Cover exposed metal surfaces with a thin coat of SAE 30 engine oil.
3. Lubricate per instructions under LUBRICATION & STORAGE section.