Marshalltown 59020A Mixer - Manual (Page 8)

7
5-SET-UP AND ASSEMBLY
This mixer is shipped partially disassembled and requires assembling.
1. Remove five ¼-20 x ½ hex hd. Cap screws, lock washers and hex nuts that secure
cover to the belt guard. Remove cover. (Save All Hardware)
INSTALL MOTOR KIT PER INSTRUCTIONS
2. Replace the cover removed in step 1 and secure with hardware (saved). Tighten
securely
3. Bolt the tilt wheel assembly to the tilt pinion. Tighten the set screw securely.
4. Although the mixer was lubricated at the foctory, now is a perfect time to become
familiar with points requiring regular service. Refer to the LUBRICATION AND
STORAGE section.
5. All nuts and cap screws should be checked and tightened during the first two
hours of use. Periodic checks should be made thereafter.